La Crosse Technology BC-700 Alpha...
La Crosse Technology BC-700 Alpha Power Battery...

List Price:$49.95
Price: $29.99
  • Features 4 modes: charge, discharge, refresh, and test
  • Overheat-detection to prevent over-charging
Sanyo Eneloop 4 Pack AA NiMH...
Sanyo Eneloop 4 Pack AA NiMH Pre-Charged...

List Price:$21.99
  • Compact charging kit with quartet of 2,000 mAh AA batteries for digital cameras, remotes, and more
  • Pre-charged and ready to use right out of the pack; preserves charge for long periods of time
Duracell Value Charger With 4AA Pre...
Duracell Value Charger With 4AA Pre Charged...

List Price:$16.29
Price: $14.99
  • Compact size is great for travel
  • LED to indicate charge status
Sony BCG-34HRMF4 Battery Charger with...
Sony BCG-34HRMF4 Battery Charger with LCD...

List Price:$39.99
Price: $27.65
  • LCD display to monitor all 4 charging circuits
  • Universal voltage from 100-240V
Sanyo 277265 Eneloop Power Pack with...
Sanyo 277265 Eneloop Power Pack with Battery...

List Price:$59.99
  • Worry-Free: eneloop works in any device that uses AA, AAA, C or D batteries
  • Kit Contents: 1 eneloop Ni-MH battery charger, 8 AA eneloop batteries, 2 AAA eneloop batteries, 4 C size adapters, 4 D size adapters

Nissan's Greener-than-chlorophyll EV: The LEAF

In person, Carlos Ghosn, CEO and all-around-savior of Renault-Nissan, does not strike anyone as an Earth-hugging counterculture type – the man’s shoe collection is probably worth more than a Brentwood mansion.  You

 Instead, Ghosn has thrown his company into a full-on EV

 The car will be produced in Japan and at Nissan’s facility

via Los Angeles Times

^

Can you connect a battery charger and a battery in series to double the voltage output ?


With the series organization the current will probably be limited by the battery charger. With the parallel arrangement, the full common will be obtained only when the batteries are freshly charged. As the batteries are discharged the around from the charger will be diverted from the final load into recharging the batteries.


With the series set-up the current will probably be limited by the battery charger. With the parallel arrangement, the full widely known will be obtained only when the batteries are freshly charged. As the batteries are discharged the bruited about from the charger will be diverted from the final load into recharging the batteries.


Bobby, the replication given by Peter H is correct but you probably need a more particularized caution. The impedance of the battery charger is very likely to be high and would limit the contemporary that you could get to flow in your electrolyte. If you were working in my workshop or laboratory, I would not sanction you to connect these devices in series and nor would I allow you to connect the devices in correspondent to produce a heavy current supply. Battery chargers are for charging batteries and being half-sea in most cases, are not particularly suitable for the electrolysis of water to supply hydrogen. Batteries, most especially wet cells, are dangerous if hardened inappropriately. My advice is that you determine the exact characteristics of the yield that you need, and obtain such a supply.

Can i use a battery charger for a power supply?


it will occupation, but it isn't regulated. It could easily put out over 20 vdc on small loads. I would way the output unloaded with a meter and compare it to when you hook up your emblem. This will run most devices as long as they are not too critical on the voltage inputted.

The ratings of 50 amps @ 12vdc is occupied to tell you at 12 volts this is the max current, not that the output is 12vdc.